Results 1 to 4 of 4
Thread: Pulling a VAC!!!
Threaded View
-
08-06-2010, 03:59 AM #1
Pulling a VAC!!!
What happens when a vac is not properly pulled?
I noticed that my helper was using the 3/8 hose on the manifold and forgot to cap the other port on the vac when we got to the second job. Can I suck the Ref (410A) back into the compressor and pull a Vac or is the Ref (410A) contaminated?? The unit was running a little high but it was condensing a lot.
What should I do???
Similar Threads
-
Low condensing pressure on freezer, not pulling temp
By Crypton in forum CommercialReplies: 6Last Post: 09-06-2010, 05:13 PM -
Pulling faster vacuums
By Aranon in forum FundamentalsReplies: 31Last Post: 04-09-2009, 07:32 PM -
Mitsubisi problem in pulling down temperature
By teguh in forum TransportReplies: 8Last Post: 21-08-2009, 05:36 AM -
Vacuum pump not pulling good suction
By marinechiller in forum Trouble ShootingReplies: 5Last Post: 15-07-2009, 10:27 PM -
Freezer not pulling down to Temp
By ferret82 in forum CommercialReplies: 5Last Post: 23-03-2009, 10:59 PM