Results 1 to 21 of 21
Thread: Valve "Hunting"
Threaded View
-
12-08-2001, 11:39 PM #1
Valve "Hunting"
My "book" wont arrive for a while so I have another question.....
TXV hunting........How does one ascertain when a valve is doing this, a recent installation the back pressure kept fluctuating between 30 Psi and 25 Psi, which I can gather was the valve shutting down and opening up again. I could also tell from the compressor noise as the load increased and decreased. Was the valve hunting? Or should the back pressure have remained stable throughout its operation with a minimal fluctuation.
System was running on R404a, 1.5hp hermetic LBP compressor, chilling down to +1 C.(cabinet ytemp)
Evaporating temperature around -28C.
Danfoss valve with a number 1 orifice, or capsule....
Valve bulb was fixed tight to the side of the return pipe on the evaporator.Last edited by Abe; 21-10-2001 at 07:22 PM.
Any opinions, statements and facts expressed in this message do not constitute legal advice in any shape or form and is given for a general outlook in nature. You are advised to seek appropriate and specific professional assistance from a regulated and authorised advisor for definitive advice.
Similar Threads
-
Fitting an expansion valve question
By Larry2 in forum Air ConditioningReplies: 20Last Post: 08-04-2008, 04:17 PM -
changing to automatic valve
By donato in forum Technical SpeculationsReplies: 2Last Post: 29-07-2006, 12:50 PM -
Scotsman commercial H2O inlet valve
By fullcourt in forum Trouble ShootingReplies: 9Last Post: 25-04-2006, 11:41 PM -
Need a correctly sized valve
By Abe in forum CommercialReplies: 2Last Post: 26-10-2005, 08:42 PM -
TEV with MOP: how to keep valve body temp above bulb temp?
By DaBit in forum FundamentalsReplies: 5Last Post: 16-10-2002, 12:38 AM