Results 1 to 3 of 3
Thread: Screw overhauls on site
Threaded View
-
25-12-2009, 07:24 AM #1
Screw overhauls on site
I notice on a few of the albums on this site people overhauling screws on site .
I can't help but think this would be more difficult than it has to be .
Whats the reason for this , are they to hard to get out of plantroom or remote locations ?
There is 1 Howden 321 , it must be difficult in a plantroom that is running as well as physically lifting everything .
Similar Threads
-
VSD on screw machines
By Mike Hopkins in forum New TechnologiesReplies: 14Last Post: 20-02-2011, 12:10 AM -
Slide valve wear on Grasso screw after just 54000 Hrs
By Lodiev in forum Technical SpeculationsReplies: 11Last Post: 14-09-2009, 01:21 PM -
Compressors - screw or reciprocating?
By Josip in forum Industrial CompressorsReplies: 18Last Post: 27-01-2009, 10:36 PM -
advantage of twin screw compressor over single screw compressor
By azzah in forum New to REReplies: 7Last Post: 23-09-2008, 09:24 AM -
Mono or twin screw
By Nirmalya in forum Industrial CompressorsReplies: 43Last Post: 12-09-2006, 03:19 AM