Results 1 to 6 of 6
Thread: burn outs
Threaded View
-
31-05-2009, 06:02 PM #1
burn outs
I have a small Liebert mini mate. We had a leak in it we put dye in to find leak. System had burned out after dye was put in. There was a coating on every piece of the high side components. Compressor, piping, txv and plate condenser had to be changed. my question is did the dye cause the burnout? (create an acid enviroment) I have seen burn outs, but not to this extent. The refrigerant is 407C,poe oil. The smell was horrific.
Similar Threads
-
System Burn Out Troubleshooting
By altaf22m in forum Technical DiscussionsReplies: 13Last Post: 07-05-2010, 09:24 AM -
Frequent compressor burn outs
By askannan in forum Trouble ShootingReplies: 17Last Post: 17-04-2008, 08:05 AM -
Burn out System, Clean up procedure. & Troubleshooting.
By altaf22m in forum CommercialReplies: 19Last Post: 15-04-2008, 07:03 PM -
Motor burn outs
By bernard in forum Industrial CompressorsReplies: 8Last Post: 25-06-2005, 11:00 PM -
Burn out procedures
By reggie in forum FundamentalsReplies: 13Last Post: 22-01-2003, 06:06 PM