My fridge-freezer quit working tonight - it's probably over ten years old and I think it might be a Candy, but I'm not sure. It switched on, ran normally for about ten seconds and then switched off with a loud click. The start/overload device is a Klixon, and I can see some physical damage to the unit. So, I want to try hard-wiring it but I'm struggling to identify the compressor terminals. It's an Embraco PW 5.5A, and the pins form an upside-down triangle, so there are two pins on the same level with a single pin in the centre, below. Does anybody happen to know which are the Common, Start and Run, please?

Also, I'm only getting continuity between two pins - that's 45 ohms, but no continuity across the other two sides of the triangle. Does anybody know if this compressor contains an internal capacitor, which would account for the lack of dc continuity with my ohmmeter. Thanks.