Results 1 to 7 of 7
Thread: TX Valve Selection: PHT or TE
Threaded View
-
31-07-2008, 06:30 AM #1
TX Valve Selection: PHT or TE
Dear all,
I have a job with 200KW capacity(R22,ET -20C,CT:40C) . I tried the selection with Danfoss program. It looks like TE55-50 is the best selection. But it doesn't have a flange set for welding to the steel pipe. I am questioning about the installation and the later mantenace of the vavle. It is packaged equipment and is far away. The PHT85-3 is ok and has flange set. But the PHT is much more expensive than TE.
Does anybody have comments on the situation?
thanks in advance for your help.
J
Similar Threads
-
Expansion Valve Selection
By raviperumal in forum Technical SpeculationsReplies: 12Last Post: 17-02-2010, 09:58 AM -
R22 Flooded System - Trawler
By chiefbecker in forum System OptimizationReplies: 18Last Post: 07-02-2008, 11:11 PM -
Service Procedures For TK Scroll
By absolute-zero in forum TransportReplies: 0Last Post: 03-02-2008, 07:42 PM -
Benji
By benji in forum Trouble ShootingReplies: 29Last Post: 30-01-2008, 01:25 PM -
PM valve selection
By lana in forum NH3Replies: 21Last Post: 19-06-2007, 01:20 AM