Results 1 to 7 of 7
Thread: brazing problems.
Threaded View
-
16-10-2007, 08:18 PM #1
brazing problems.
hi guys, could somone please advise me on the following problems.
1: what pressures should the oxygen and acytelye forgive the spelling be set at for brazing.
2: which are the correct rods to use for brass to copper piping and a 4 way valve to copper piping. thanks. i know this basics but i found im either to cold or burn holes in pipes. thanks.
Similar Threads
-
Brazing vs. soldering
By DaBit in forum FundamentalsReplies: 28Last Post: 19-03-2011, 11:50 AM -
brazing rod standards
By brian1 in forum CommercialReplies: 5Last Post: 02-05-2009, 12:00 AM -
Oversized Liquid Recievers?? Problems??
By nickjh in forum FundamentalsReplies: 12Last Post: 12-06-2007, 07:54 AM -
Oil return problems
By Peter_1 in forum IndustrialReplies: 37Last Post: 23-08-2004, 11:30 PM -
oil pressure problems on air dryer
By edge in forum Trouble ShootingReplies: 1Last Post: 16-07-2002, 02:10 PM