Results 1 to 6 of 6
Thread: compressor vibration
-
21-09-2007, 01:25 AM #1
compressor vibration
pump down system
At the cut out the copmpressor makes noise and vibrates.
Please advice.
thanks.
-
21-09-2007, 03:33 AM #2
Re: compressor vibration
Last edited by taz24; 21-09-2007 at 01:37 PM. Reason: Realised I was talking rubbish.
-
21-09-2007, 11:47 AM #3
Re: compressor vibration
What type of compressor is it, oh yes - hello.
Brian - Newton Abbot, Devon, UK
Retired March 2015
-
25-09-2007, 02:14 PM #4
Re: compressor vibration
can you check with your pressure gauge the cut off setting of the low pressure cut out.it may be setted at very low range that possibly bring the compressor running at vacuum.there may be chance of vibration and noise. i only base this on my own experience.
Just try.
-
25-09-2007, 11:02 PM #5
Re: compressor vibration
It could be that the Compressor is pumping down too low and too quickly. This can cause oil forming, which in some cases cause the Compressor to rattle.
Not very healthy for Compressors.
-
25-09-2007, 11:18 PM #6
Re: compressor vibration
Hello Hitch,
Im long time not in field but in my experince
mostly i found is the rubber mounting of compressor and some times when i open the compressor the spring that holding the compressor came off,they are right may be low pressure.the other also if control either by pressure or thermostat the setting is very near ,the pressure is not equalize then it will start again.its so many causes actually. Im sorry im not expert.
Thanks
Cesar