Results 1 to 10 of 10
Threaded View
-
06-08-2007, 02:16 PM #1
Evaporative Condenser Presure Lost
Hello Gentlemen
My question is : How to figure out the presure drop in a evaporative condenser and a set of condensers installed in parallel?
As you know a presure drop of just 1Psi (0,068 bar) higher between condensers is very import to to disign the seal leg at the piping outlet . Also this liquid seal is very import to purge Non Condensables Gases.
I will appresite your opinions
Best regards
Similar Threads
-
Evaporative Condenser in reverse cycle
By Friobernal in forum IndustrialReplies: 6Last Post: 16-04-2009, 02:06 PM -
Ammonia evaporative condenser surface
By Gonzalo Arias in forum NH3Replies: 4Last Post: 20-04-2007, 06:58 PM -
evaporative condenser
By Lc_shi in forum FundamentalsReplies: 16Last Post: 02-05-2006, 08:25 AM -
Evaporative condenser surface area
By Gonzalo Arias in forum FundamentalsReplies: 5Last Post: 06-08-2005, 11:27 PM -
Evaporative condenser pipe surface
By Gonzalo Arias in forum Tools and CalculatorsReplies: 0Last Post: 03-08-2005, 12:33 AM