Results 1 to 1 of 1
-
30-07-2007, 03:21 PM #1
condensing water pump overhauling
Dear techs:
I am in the process of overhauling an old condensing water pump. The brand of the pump is yet unknown. What I am certain of is that the shaft is supported by two bushing type bearing inserts located at each end of the pump casing. I was able to press out the shaft and impeller, but I am not sure on how to get the buhings out of their holes. They look fragile, and I don't want to try prying or tapping . Any suggestions welcomed. By the way, they are about 40 mm I.D. and about 2 mm thick.
Similar Threads
-
heat pump to boil water
By Lc_shi in forum New TechnologiesReplies: 36Last Post: 15-09-2010, 09:04 PM -
pure water from air
By Lc_shi in forum New TechnologiesReplies: 32Last Post: 26-02-2009, 12:25 PM -
Homemade Heat pump water heater
By busman in forum Technical DiscussionsReplies: 20Last Post: 05-02-2008, 04:04 PM -
VFD heat pump water heater?
By star882 in forum New TechnologiesReplies: 0Last Post: 23-05-2006, 08:36 PM -
Building a wine cabinet
By Rory in forum Technical DiscussionsReplies: 38Last Post: 13-07-2004, 08:28 PM