Results 1 to 10 of 10
Thread: Cutting unistrut
-
23-04-2007, 09:05 PM #1
Cutting unistrut
Hello again guys, have any of you got or used a circular saw for cutting unistrut and cable trays? I've seen an Evolution Rage2 saw with a fancy blade, even watched their promo video for it , but before splashing out on one I would be grateful for anyones views on them - ease of use, blade life etc. I've got a lot of strut to cut soon, but my colleague is so slow at cutting and can't cut anywhere near straight.
Andy
-
23-04-2007, 11:26 PM #2
Re: Cutting unistrut
We got a 110v one for a big VRF job a while back - it paid for itself in a day.
It does leave razor sharp edges so you will need plastic caps or have someone file the ends down. You need lots of room, it throws sparks all over the place and makes a racket. Long heavy lengths can be a bit tricky as they can put it off balance.
Make sure its got a decent guard and clamp. Be careful - it would chop off all your fingers in one second.The blades do go quite quickly (on metal, not fingers)!!
-
23-04-2007, 11:37 PM #3
Re: Cutting unistrut
I've got a makita TCT blade chop saw for unistrut ABS pipe etc. Still on original blade after 8 years (only used once a month or so) Not too many sparks but it fires little chips everywhere, goggles a must have.
Am thinking of getting one of those battery angle grinders for cutting plastic trunking, need a bigger van.
Cheers Jon
-
24-04-2007, 07:56 AM #4
-
24-04-2007, 12:11 PM #5
Re: Cutting unistrut
-
24-04-2007, 01:33 PM #6
Re: Cutting unistrut
Thank you Paula
-
24-04-2007, 08:09 PM #7
Re: Cutting unistrut
hi Andy,
i use a 18v dewalt reciprecating saw cuts uni all day long plus many other uses and portable
-
04-05-2007, 02:34 AM #8
Re: Cutting unistrut
What Andy said. ^^^^^^^
-
27-05-2007, 08:06 PM #9
-
27-05-2007, 09:32 PM #10
Re: Cutting unistrut
Thanks for the replies guys. I saw one of those rage saw at my local b&q and it wasn't built as good as I thought it was. I ended up getting a 24V makita reciprocating saw as a body only to go with the batteries from my old sds drill. Used it more for cutting fence posts and old pallets, but it does cut the strut really well
Andy