Results 1 to 2 of 2
Thread: Roll Bonded Evaporator
-
24-02-2005, 01:19 PM #1
Roll Bonded Evaporator
I am being told by manufacturer that a roll bonded evaporator which was pressure tested by one of our engineers should not be pressure tested as it is too fragile. As I am not technically trained and work in the office can someone tell me how this should be leak tested?
Thanks
Vicky
-
24-02-2005, 01:57 PM #2
Re: Roll Bonded Evaporator
It is a bit risky for the evaporator but if you do not exceed 4 bar, it should be ok.
Chemi
Similar Threads
-
Designing Roll Bond Evaporator
By Munzar Ata in forum FundamentalsReplies: 11Last Post: 05-08-2010, 11:31 AM -
Air Source Heat Pump - temp of refrigerant leaving evaporator
By anup in forum FundamentalsReplies: 3Last Post: 06-11-2006, 05:04 AM -
Evaporator Design-Air Source Heat Pump for water heating
By anup in forum Technical DiscussionsReplies: 7Last Post: 20-03-2006, 02:26 PM -
Change evaporator
By tralex in forum FundamentalsReplies: 6Last Post: 29-12-2005, 07:53 PM -
Iced Evaporator
By Abe in forum CommercialReplies: 13Last Post: 06-11-2002, 01:34 PM