Program for PC

[Flashy]

I'm loking for a simpel program where jou can get the same information like on a Pressure/temperature slide .

[Brian_UK]

Download CoolPack.

[sammycclass]

[quote=sammycclass;205263]Hello



I have Thermo King with a RD II shut down problem.
Don’t know what to do any more I did check some wires look ok. Check oil and water ok
Starts some times shuts down ride away and sometimes runs for a few minutes when I adjust the rpm screw to high rpm is ok so I get the fallowing codes 71 77 61 sometimes code 74 as well please help

Thank you

[Peter_1]

Or Solkane from Solvay

For Sammycslass, nobody will answer you post if you don't do the efforts to post it in the right section

[clivemtk]

code61 =low battery voltage try fitting a slave battery and run on test

[Flashy]

Download CoolPack.

Thanks for the fast reply

[sammycclass]

I did check all battery connection and power and ground all ok will start and turn off so I check contacts all ok check diesel in to fuel filter all ok check oil and water all ok removed circuit board cleaned all contacts with contact cleaner because I have seen some light mildew on the circuit board removed & reinstalled back now control panel in cab will not light up if I turn on black switch on position it will turn on and off buy itself so don’t know what to check any more please help.

Thank you

[Lodiev]

I have a pocket refrigeration calculator from DUPONT witch can do all T/P conversions in a split second for all common used gases. I got it from a local refrigeration spares company that cells DUPONT gases. So try your local gas supplier.Keep on Topic PLZ

[mcjo tech]

I'm loking for a simpel program where jou can get the same information like on a Pressure/temperature slide .

www.exactchargehvac.com

Click on ExactCharge Calculator on left hand side.

Click on Conv key for SI Mode.

Instructions are also available.

[mcjo tech]

I'm loking for a simpel program where jou can get the same information like on a Pressure/temperature slide .

www.exactchargehvac.com

Click on ExactCharge Calculator Icon on left hand side.

Click on Conv key to convert to SI Mode.

Instructions are also available.

Free.