Results 1 to 10 of 10
Thread: Password
-
06-09-2006, 06:36 PM #1
Password
help please. how to disable the password on eliwell id961 controller.
-
06-09-2006, 07:03 PM #2
Re: Password
Password ?
Never come accross that, what are you trying to do
Normal you push and hold in order
bottow right
top left
top right for 3 seconds and it should let you into the parameters.
Let know exactly what you are doing and we might be able to give you a more precise answer
Regards
fatboy
-
06-09-2006, 11:08 PM #3
Re: Password
Download the instructions here:-
http://www.hawco-refrigeration.co.uk...l/EWPC_961.pdfBrian - Newton Abbot, Devon, UK
Retired March 2015
-
07-09-2006, 04:37 PM #4
Re: Password
thanks for that but my model is id961 which is a single centre /off/on and not so complicated as the ewpc 961 regards
-
07-09-2006, 04:57 PM #5
Re: Password
go to parameter:
PA1, PAssword 1. when enabled [value aotther than 0]
it costitutes the access key for level 1 parameters.
Tio make your life easier, try here,
http://www.invensyscontrolseurope.co...LXeng42002.pdf
Chemi
-
07-09-2006, 05:08 PM #6
Re: Password
thanks for that. pa1 displays but no one has the password how do i get in with out a password.regards.
-
07-09-2006, 06:18 PM #7
Re: Password
hi problem solved.hard slog with all possible combinations until the correct one did the job. thanks gentlemen to all concerned. regards.
-
07-09-2006, 09:14 PM #8
Re: Password
Yamaha is asking - I think - anoter question.
What if someone has entered a password and you want to change a parameter without knowing this password.
You can go back then to factory settings.
This is possible but I forgot how.
I will give you the answer tomorrow after I have called my wholesaler.It's better to keep your mouth shut and give the impression that you're stupid than to open it and remove all doubt.
-
08-09-2006, 04:38 AM #9
Re: Password
Yamaha,
Go as others said to PA , then SEt, then with the arrows up to 135 and again SEt.
For the other controllers, the password is:
EWPC...........13
EWPX............13
EWDB............PS1 =135........PS2=235
EWDA/EWDL/EWDS/............PS1=PS2=135
EWDC112/222......................71
EWDC232............................13
ID...................................135
This is information you can't find on the Invensys/Eliwell website nor in the manuals!!It's better to keep your mouth shut and give the impression that you're stupid than to open it and remove all doubt.
-
08-09-2006, 04:32 PM #10
Re: Password
thanks for that PETER 1 good information.as you will see i am not a refrigeration engineer but a first line repair in a large food store. the refrigeration lads would have set there own password to keep fingers out. as i said all is sorted and thanks again.regards.