Removing Daikin PCB - RZP125DV1

[CPerry]

Hi
I am trying to remove PCB PC0104H-1 from Daikin RZP125DV1
Have disconnected plugs and wiring and the two screws
Board only moves a few millimeters horizontally but will not lift up
Still seems to be being held down around where the screws were
If any one has any ides please advise what is required to release the board
Thanks
CP

[frank]

Here's a link to the instructions
https://www.manualslib.com/manual/86...age=225#manual

[CPerry]

Here's a link to the instructions
https://www.manualslib.com/manual/86...age=225#manual

Hi Frank
Really appreciate your link to the manual
Unfortunately I've done what it says relating to removal of PCB and it will not lift out
With a bit of pressure the board moves horizontally about 5mm left to right, and front to back
It will also rotate within the limits of the plastic switch box and seems to pivot between where I have removed the the two screws - probably a closer to the left one.
I can lift the edges of the board up a little as it flexes, but it still feels locked down around the mounting screw holes
Just wondering if you have any ideas what maybe holding it down and how to release it
Thanks
Colin

[martinw58]

it might be stuck on heat sink paste

[frank]

Have you carried out Step 3 on the next page of the manual?

[CPerry]

Have you carried out Step 3 on the next page of the manual?

Thanks for your help
The board was just stuck on the heat sink paste and I have been able to remove it

[frank]

Thanks for the update