Results 1 to 1 of 1
  1. #1
    Join Date
    Jan 2008
    Rep Power

    Trane ECGCE205 Programming


    1994 Trane ECGCE205 2 Circuit, 4 compressor

    I have recently replaced the circuit A controller board. After replacement it did not appear to recognise the circuit B module and would only run compressors on the A circuit regardless of the circuit selector switch on the B module.
    This seems to be due to the new controller needing to be programmed, I managed to change what must have been the setting for the number of circuits and got both circuits to operate. Iím a bit concerned that I may need to set up other parameters and wondered if anyone would have a programming manual for one of these.

    Attached picture is from an identical chiller on site.

    Many thanks
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts