Just an update after the advice...

We found a contractor on the delta side to have failed. The coil looked to have been fried. Replaced the contractor and works well now and fixed the leak.

However. Now circuit 1 seems to be having issues. Fix one thing another comes up eh..

Circuit 1 will run for about 5 or so minutes give and take then just pop out and goes through ar timer again.

I’m looking into it but it’s a mare as you can imaine. Believe it to be electrical still, possibly something warming up then popping out into fault.

No warning comes up on display so I can’t tell what it is

Any ideas on this one as scratching my head.

Going to check solenoid coils, contractors and know the motor protection module is ok. Swapped this other and no issues transfered across.

Thanks