Results 1 to 2 of 2

Thread: Pressure drop

  1. #1
    Join Date
    Aug 2013
    Location
    RF
    Posts
    5
    Rep Power
    0

    Pressure drop



    Hi!
    How are you?

    I have absolutely stupid question, but I'll appreciate you for your assistance.

    I faced the problem. I am going to design some valves like solenoid valves or some pressure regulators and all instructions say I have to design according to the pressure drop across the valve. How this pressure drop should be calculated?

    For example, I have a system (R717) with an anhydrator (8TR). I need to calculate solenoid valve on the line from the anhydrator to HP receiver. What the pressure drop?

    Thank you!



  2. #2
    Brian_UK's Avatar
    Brian_UK is online now Moderator I am starting to push the Mods: of RE Site Moderator : and general nice guy
    Join Date
    Mar 2001
    Location
    Dorset
    Age
    70
    Posts
    10,602
    Rep Power
    52

    Re: Pressure drop

    I think that you are looking at this subject back to front.

    Valves and other components have a kvs or pressure drop across as stated by the manufacturer. That kvs value is used to calculate your system pressure drop allowing for the pipework and fittings installed.

    If you need a specific pressure drop across a component then you use the appropriate sized item.

    If you utilise the laws of physics then you should be able to calculate the kvs value of your component, if not then a test rig could be built to test your designs.

    Check also Sporlan document 30-10 for solenoid valve sizing.
    Last edited by Brian_UK; 18-05-2018 at 03:34 PM.
    Brian - Newton Abbot, Devon, UK
    Retired March 2015
    Please support http://the100project.net/Home

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •