Results 1 to 3 of 3
  1. #1
    Join Date
    Sep 2007
    Location
    Somerset
    Age
    69
    Posts
    4,758
    Rep Power
    46

    Removing one SFA15 From a DSV1 Dual manifold. (Danfos)



    Hi Guys.
    Can anyone advise as to the actual male thread size on the bottom of a Danfoss SFA15 to enable that port on the DSV1 dual manifold to be used to Push pull the Ammonia from a Sabroe Pac system.
    Basically I need to identify the Port thread size to make up an adaptor.
    Which in turn can be connected to, to facilitate the system being emptied of Ammonia.
    My guess is 1" BSG. /BSP.
    Can anyone clarify?
    Thanks.
    Grizzly


    Despite the High Cost of Living it still remains Popular!

  2. #2
    Brian_UK's Avatar
    Brian_UK is offline Moderator I am starting to push the Mods: of RE Site Moderator : and general nice guy
    Join Date
    Mar 2001
    Location
    Dorset
    Age
    75
    Posts
    11,192
    Rep Power
    60

    Re: Removing one SFA15 From a DSV1 Dual manifold. (Danfos)

    3/4" inlet and 1" outlet BSP according to their spec sheet.

    http://products.danfoss.co.uk/produc...e-dependent/#/
    Check under Documents.
    Brian - Newton Abbot, Devon, UK
    Retired March 2015

  3. #3
    Join Date
    Sep 2007
    Location
    Somerset
    Age
    69
    Posts
    4,758
    Rep Power
    46

    Re: Removing one SFA15 From a DSV1 Dual manifold. (Danfos)

    That was quick Brian.
    Impressive.
    Thanks.
    Grizzly
    Despite the High Cost of Living it still remains Popular!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •