Results 1 to 5 of 5
Thread: Emerson PAC networking
-
14-12-2017, 06:22 AM #1
Emerson PAC networking
Hi!
Hope all are well. i just facing a problem about 2 Emerson PAC networking that is how to connect 2 PAC (medium icom board to board) via crossed Ethernet cable? I did set unique IP address, U2U address etc. but it's not working!!
-
14-12-2017, 12:30 PM #2
Re: Emerson PAC networking
Are all the settings like that?
Last edited by narkom; 14-12-2017 at 12:34 PM.
-
18-12-2017, 03:41 AM #3
Re: Emerson PAC networking
Thank you, narkom. Yes, all settings are like that. But it's not working. Local Vertive(Emerson) authorised person told me that 'medium board cannot be connected via crossed cable! Is it right?
-
18-12-2017, 05:55 PM #4
Re: Emerson PAC networking
No, it is not. If you can connect a Coldfire display to medium board via crossed cable you can connect two medium boards via crossed cable. Why did you decide it is not working? Is there an Alarm message "Unit ## disconnected" or something else?
Last edited by narkom; 18-12-2017 at 05:58 PM.
-
07-01-2018, 06:34 AM #5
Re: Emerson PAC networking
Yes, there is an alarm that is "No connection with unit 01" or "unit 2". but crossed cable is connected and cable is checked and okay.
Last edited by Bipu; 07-01-2018 at 06:38 AM.