Good day guys,
I had a leaking fitting on the compressor which is sealed by an oring that seats against the compressor body and threads into a fitting in the compressor that resembles a pickup tub but functions as a distributor for the liquid injection to bring down the compressor temp. I removed the fitting and replaced the oring to address the leak but now I cannot get the threads to bite because the internal female fitting/distributor has moved and I can’t get the two components to line up.
Has anyone ever had this problem and have a reasonable solution?? I’m going to remove the throttling valve to attempt to get the female side to line up with the hole in the compressor and/or remove the end bell to get access to the internal fitting.
HAS ANYONE EVER HAD THIS PROBLEM. HELP!!!
Thx....