Results 1 to 3 of 3
Thread: Hitachi samurai chiller problem!
-
25-05-2006, 10:15 PM #1
Hitachi samurai chiller problem!
Hi all!
I had one of those great call-outs today,an invitation to spend the next week or so getting to know a Hitachi chiller. It`s a samurai RCUE120AG that suffered a lot of water contamination due to a blown plate heat exchanger . Apart from the repair, mammoth vac down times with a few drier changes and a oil change, what other things would you suggest to look out for?
My main concern is the screw compressor and what damage it has suffered. I have little experience with screw pots. Will it need a stripdown or do they normally survive? (It sounded ok when operated for 3-seconds after the system was drained).
If anyone has done this type of work before or could give any suggestions on what things to look out for I would be very greatful.
-
28-05-2006, 02:27 AM #2
Re: Hitachi samurai chiller problem!
Originally Posted by MRcoolingMAGIC
-
28-05-2006, 09:39 AM #3
Re: Hitachi samurai chiller problem!
They Had Just Started To Use These On The Cadbury Site In Birmingham When I Left. We Were Told They Compressor Was Not Serviceable And You Just Changed Them Out. The Suppliers Were Axair In Solihull. Give Them A Bell They Were As Good As Gold When I Wanted A Manual Of The Fault Codes
Similar Threads
-
Hitachi Air-con Problem
By oddjob in forum Air ConditioningReplies: 10Last Post: 12-05-2008, 01:46 AM -
York Screw Chiller How low will it go?????
By bruceboldy in forum Industrial CompressorsReplies: 11Last Post: 10-08-2007, 10:29 PM -
Strange problem
By Peter_1 in forum ElectricalReplies: 9Last Post: 10-04-2007, 05:19 PM -
Chiller Fault
By iceman007 in forum Air ConditioningReplies: 2Last Post: 13-05-2006, 07:23 PM -
Problem with centrif - help requested
By Brian_UK in forum Industrial CompressorsReplies: 5Last Post: 03-08-2005, 10:31 PM