Hi Guys & gals
We got the new flarings spin tools into our workshop to test. I have to give my opinion as I found them difficult to use and a few problems with the flare and swage.

The swage tool picked up burrs inside the copper tube and the flare tool made an awful flare.
The copper is hard to hold as it gets very hot and the flare is distorted with an exaggerated cone on the flare.

As i was not the only one to use it, we got it tested by three different engineers and our opinion is that it is not worth the money and the time saved over an actual flaring tool is just not worth it.
http://www.flaringspin.com/

I would appreciate someone elses opinion on these tools and even after watching the you tube videos we cant get the same quality flare and swages repeated in actual working applications.