Results 1 to 6 of 6
Thread: Wiring a sauter actuator
-
24-06-2017, 09:16 AM #1
Wiring a sauter actuator
I need help wiring an actuator from a controller board that has 3 wires
On the photo wiring diagram it is 25,26 and 27
Thanks in advanceIMG_4675.jpg
-
24-06-2017, 02:30 PM #2
Re: Wiring a sauter actuator
Which actuator do you have? Little clues make thing easier
-
24-06-2017, 08:27 PM #3
-
24-06-2017, 11:43 PM #4
Re: Wiring a sauter actuator
Is it a 2 port or 3 port valve and do you have any other controls in line with it, i.e. open or close commands.
[Edit] Checking the drawings again I reckon you need scheme 5a but without the feedback loop, so---->
Controller - function - actuator
25 - 2-10v signal - 03
26 - 0 volts - MM
27 - 24 volts - 01Last edited by FaultCode; 24-06-2017 at 11:48 PM.
-
26-06-2017, 09:07 PM #5
-
21-08-2017, 04:01 PM #6
Re: Wiring a sauter actuator
Should have gone for a Belimo ..