Results 1 to 7 of 7
  1. #1
    Join Date
    Jun 2017
    Location
    Brasil
    Age
    53
    Posts
    5
    Rep Power
    0

    GEA Grasso Screw compressors



    Hello everyone,
    I am very happy to be part of this group.
    I need the manuals with disassembly and assembly procedures that have the measures of adjusting the bearing clearances and the measures of the ropes of the rotors and bearings with the tolerances of the GEA Grasso compressors.
    Models: XCR-XC26B-28 and YR-Y26S-28.

    Thank you very much for any help you can give me.

    I extend to everyone.



  2. #2
    Join Date
    Dec 2007
    Location
    australia
    Posts
    3,356
    Rep Power
    39

    Re: GEA Grasso Screw compressors

    Souza,
    Check your email for some information.

  3. #3
    Join Date
    Dec 2007
    Location
    australia
    Posts
    3,356
    Rep Power
    39

    Re: GEA Grasso Screw compressors


  4. #4
    Join Date
    Jun 2017
    Location
    Brasil
    Age
    53
    Posts
    5
    Rep Power
    0

    Re: GEA Grasso Screw compressors

    I received the email, thank you.

    I have experience with Mycom compressors, if you have any questions I can help.

  5. #5
    Join Date
    Jun 2017
    Location
    Brasil
    Age
    53
    Posts
    5
    Rep Power
    0

    Re: GEA Grasso Screw compressors

    I received the email, thank you.

    I have experience with Mycom compressors, if you have any questions I can help.

  6. #6
    Join Date
    Dec 2007
    Location
    australia
    Posts
    3,356
    Rep Power
    39

    Re: GEA Grasso Screw compressors

    Souza,
    Thanks for Mycom offer.
    The Vi plates that screw into discharge housing also guide slide valve radially.
    Pay attention to this as they can wear in some machines causing slide valve to come in contact with rotors.
    Housings need special tool for aligning housings in dowel holes.
    It is an expansion dowel that lines up housings, they do not have steel dowel pins like Mycom etc.
    In our region they will lend or hire them when you buy parts, hopefully you can arrange this.
    Parts very expensive for these machines, main bearings not normally replaced, usually pretty good.
    Good luck
    Last edited by RANGER1; 13-06-2017 at 11:26 AM.

  7. #7
    Join Date
    Jun 2017
    Location
    Brasil
    Age
    53
    Posts
    5
    Rep Power
    0

    Re: GEA Grasso Screw compressors

    OK thank you.
    Do you have a photo of this tool?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •