Results 1 to 4 of 4
  1. #1
    Join Date
    Nov 2016
    Location
    Norfolk UK
    Posts
    3
    Rep Power
    0

    Lightbulb Modifying a Hotpoint RLA36 for kegerator



    Hi folks,

    Been asked to modify a Hotpoint RLA36 to take a 11 gal larger keg ! lol

    Initial plan was to cut the door about and make up a new panel with a bulge in it, but possibly looking at chopping it half and making a middle spacer.

    Apart from the thermostat capillary tube (removable) in the top, and the cable for light/thermostat, as anyone any idea where the chiller side of the heat exchanger is ?

    Initially thought it might just run in the back, but looks like it might be possibly be in the side.

    Anyone any idea ?



  2. #2
    Join Date
    Nov 2016
    Location
    Norfolk UK
    Posts
    3
    Rep Power
    0

    Re: Modifying a Hotpoint RLA36 for kegerator

    After further investigation, the way the pipes are routed to internal and external heat exchangers, it might be possible to remove the compressor and swing it round 90 degrees without any undue pipe stress and having to drain and re-charge the gas.

    Then the plastic bulge inside at the bottom could be chopped away and replaced with new plastic/foam.

    This still all depends on where the internal pipes are located, if anyone has any idea ?

  3. #3
    Join Date
    Aug 2006
    Location
    england
    Age
    43
    Posts
    3,781
    Rep Power
    38

    Re: Modifying a Hotpoint RLA36 for kegerator

    Why does the door need cutting? Usually lager barrels stand vertically. New Kegerator on amazon is between 300/400 so not sure its worth the effort adapting something that then may not work as required.
    Mostly found in Oxfordshire, UK :)

  4. #4
    Join Date
    Nov 2016
    Location
    Norfolk UK
    Posts
    3
    Rep Power
    0

    Re: Modifying a Hotpoint RLA36 for kegerator

    Quote Originally Posted by monkey spanners View Post
    Why does the door need cutting? Usually lager barrels stand vertically. New Kegerator on amazon is between 300/400 so not sure its worth the effort adapting something that then may not work as required.
    Apparently, no standard under-counter fridge is large enough to take a commercial standard 11gal keg.

    I ow the guy a favor, so mine is not to reason why
    He did say the cheapest a new kegerator that a commercial size keg would fit it was 500

    If the bulge inside, over which the compressor is located wasn't there, it would fit fine.

    Re-siting the compressor 6" behind, cutting the bulge out then lining/foam spray would appear the easiest way to get the keg to fit in.

    Just have no idea on where Hotpoint stick the cooling coils in a RLA36 and don't really want to accidentally cut through it !

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •