Results 1 to 6 of 6
Thread: johns-spanner
-
29-08-2016, 03:46 PM #1
johns-spanner
have mitsubishi PFFY-P40VLEM-E require the plug for CN31 PCB connector (drain overflow) any ideas, not a mitsubishi part?
-
29-08-2016, 10:15 PM #2
Re: johns-spanner
If it isn't a Mitsi part then what do Mitsi normally fit there?
Brian - Newton Abbot, Devon, UK
Retired March 2015
-
30-08-2016, 12:15 AM #3
Re: johns-spanner
Is this for when you fit a separate pump to a floor unit?
Never fitted one but would have thought it comes with the Mitsi pump.
Failing that use an aftermarket pump with a reservoir.
Cheers,
Andy.Health and safety first..........unless I'm in a hurry.
-
01-09-2016, 07:50 PM #4
Re: johns-spanner
this plug has a wire in a loop, if fitting a remote pump you cut into the loop and connect wires to the overflow sensor on the pump. this plug is part of the Mits unit but they claim the plug is not on there part list?
awaiting info from factory, in hope.
-
02-09-2016, 09:56 AM #5
Re: johns-spanner
I've asked for this before - part number should be 231065.
However, from memory, the part just arrived the same as the plug with the loop, so I had to cut this and carefully solder 2x tails to allow connection to the condensate pump wires.
edit: just realised the above was on a PEFY-P140VMHLast edited by Slim R410a; 02-09-2016 at 09:59 AM.
-
03-09-2016, 08:23 PM #6
Re: johns-spanner
thanks anyway will try part number with Mits.