Results 1 to 5 of 5
Threaded View
-
22-04-2016, 10:42 PM #1
Sabroe 163 mk2 manual vi with angular position transducer fault
Hello Engineers,
I am brand new to the forum, I hope that there is someone that has knowledge on the sab 163 . I have an issue with setting the Vu. I have followed the manual to try to gain a Vu of 4.5 which is 42 turns. I can only get 43 turns all the way to the end of the vi adjustment screw which when run shows a vi of 3.5 . It almost as though the capacity slide is able to open up to far, but I am unsure as to why this is with the vi spindle set correctly?. Any help gladly received.