Results 1 to 7 of 7
-
28-10-2015, 06:31 AM #1
2nd Hand Danfoss SMVE motor drive needed desperate. (S.West UK.)
Hi Guys.
I am to attend a site this morning where their SMVE actuator motor,
(E = 4-20ma signal control) has shaken itself to bits literally!
A long story and I have not time to go there.
I know these have not been supported / available from Danfoss for a very long time.
It's a long shot, I know!
But has anyone got an old usable one hanging around?
The plant needs to be kept going for the next few months. When it is due to be scrapped.
But in the meantime unless I can resurrect the existing one they are dead in the water.
Thanks Grizzly.
-
28-10-2015, 09:47 AM #2
Re: 2nd Hand Danfoss SMVE motor drive needed desperate. (S.West UK.)
Grizzly not sure if this is helpful.
http://bosch.lektronix.net/equipment...mve+24/smve24/
-
28-10-2015, 04:40 PM #3
Re: 2nd Hand Danfoss SMVE motor drive needed desperate. (S.West UK.)
Hi Grizz
Got a couple of new ones in my garage
Plus a brand new MeV 125 valve complete plus MeV gland assemblies
-
28-10-2015, 09:52 PM #4
Re: 2nd Hand Danfoss SMVE motor drive needed desperate. (S.West UK.)
Bugger!
If only I had posted earlier!
I and the customer have gone down the route of ordering a ICV housing with a ICM module and ICAD Actuator.
Time is of their essence!
All the same where (Roughly) is your Garage? It may yet prove useful!
Incidentally the MEV is a 80-6.
Thanks for the input, nice one!
Grizzly
-
28-10-2015, 09:55 PM #5
-
28-10-2015, 10:23 PM #6
Re: 2nd Hand Danfoss SMVE motor drive needed desperate. (S.West UK.)
Hi Grizz
I'm in sunny Dartford Kent on the M25 car park
-
28-10-2015, 10:37 PM #7