Hi,

We have a PURY-P400 with main and sub BC and 21 ICs. All our offices have at least one IC, some have more, each office has one remote connected directly to ICs. Total capacity of ICs is 59.1 so just under 150% limit.

We find some offices have over capacity, a few event too many ICs. Others are under capacity.

Now I was told by the maintenance guys we could:
- disable 2 ICs (was told I could move them to address 000)
- change capacity of others so we move capacity to where it is needed using SW2

Is this allowed/ok/recommended?