Results 1 to 6 of 6
  1. #1
    Join Date
    Aug 2007
    Location
    Adelaide Australia
    Age
    70
    Posts
    567
    Rep Power
    24

    Post Bitzer 6F50.2Y45P manual



    Hi All
    I am after a service manual for a Bitzer 6F50.2Y45P compressor.
    I have a complete parts list supplied by Bitzer but I am after something with clearances / tolerances / wear limits and torque settings.
    If anyone can supply this information it would be greatly appreciated.
    Regards
    Paul


    Born to fish, forced to work

  2. #2
    Join Date
    Sep 2003
    Location
    ISRAEL
    Age
    72
    Posts
    4,266
    Rep Power
    46

    Re: Bitzer 6F50.2Y45P manual

    That sort of info you can get at the compressors rebuilders, Bitzer will not supply it.

  3. #3
    Join Date
    Aug 2007
    Location
    Adelaide Australia
    Age
    70
    Posts
    567
    Rep Power
    24

    Re: Bitzer 6F50.2Y45P manual

    Hi Chemi
    We asked the rebuilder we use and all he said was about .003" clearance on bearings.
    I was hoping for a bit more, probably used to working on bigger machines where all this information is readily available.
    Regards
    Paul
    Born to fish, forced to work

  4. #4
    Join Date
    Sep 2009
    Location
    Iran
    Age
    66
    Posts
    672
    Blog Entries
    1
    Rep Power
    19

    Re: Bitzer 6F50.2Y45P manual

    hi
    0.003" is too much ( max. clearance ). it should be 0.002 " = 0.005mm up to less than 0.007 mm =less than 0.003"
    after repair run compressor with oil for about 5 min. check oil pressure and Ampere and remove the oil and clean oil filter .

  5. #5
    Join Date
    Aug 2006
    Location
    England
    Posts
    495
    Rep Power
    21

    Re: Bitzer 6F50.2Y45P manual

    Hi friend long main and short main 1.770 - 1.768 inches
    Heads /sump plate /non drive end bearing housing /45 ftlb. con rod is I think m8 do that to 15 ftlb and put 243 loctite. Terminal plate 45ftlb
    Suction cover 70ftlb

  6. #6
    Join Date
    Aug 2007
    Location
    Adelaide Australia
    Age
    70
    Posts
    567
    Rep Power
    24

    Re: Bitzer 6F50.2Y45P manual

    Hi GHAZ and mbc
    Thanks for the info on the clearances and torque settings.
    I inspected the compressor yesterday and there is no major wear, crankshaft journal size and bearing clearances are as you have stated.
    Regards
    Paul
    Born to fish, forced to work

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •