Results 1 to 6 of 6

Threaded View

  1. 22-04-2006, 01:34 PM #1
    kengineering's Avatar
    kengineering
    kengineering is offline Senior Poster
    Join Date
    Dec 2005
    Location
    USA
    Posts
    222
    Rep Power
    20

    How to adjust head on a water cooled condenser

    How do you properly adjust the head presure on a water cooled condensing unit? I was told to adjust water flow to produce a head presure equivalent to 105 degrees F (after convertion of presure to temperature) regardless of refrig type. Also, how much does the entering water temperature influence this procedure.

    I have a need to set up a display case for shipping. I will only have tap water, which is approximately 55 degrees F, for the set up. If the location has a cooling tower I'm fairly certain it will be a different temp than my tap.
    Ken
    Last edited by kengineering; 22-04-2006 at 03:49 PM. Reason: additional comments
« Previous Thread | Next Thread »

Similar Threads

  1. pure water from air
    By Lc_shi in forum New Technologies
    Replies: 32
    Last Post: 26-02-2009, 12:25 PM
  2. water cooled condenser shell type
    By abbasi in forum New Technologies
    Replies: 0
    Last Post: 27-04-2005, 08:32 AM
  3. Building a wine cabinet
    By Rory in forum Technical Discussions
    Replies: 38
    Last Post: 13-07-2004, 08:28 PM
  4. water cooled condensers
    By aaron crimmins in forum Fundamentals
    Replies: 2
    Last Post: 22-07-2002, 04:24 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules