Results 1 to 5 of 5
-
22-10-2014, 10:30 AM #1
Not receiving remote signal - older Fujitsu model split system
Hi All,
Not sure if anybody can help. I have an older model split system A/C in my loungeroom - Fujitsu AST24RGB-W. There's absolutely no response from the remote control.
The remote is still putting out a signal (pointed it at my digital camera), but there's no response from the A/C. I figured the IR receiver had died, so I pulled out the IR board and saw a blown capacitor. I replaced it, but it still doesn't work.
So, either my repair job was terrible (I haven't soldered anything in about 15 years, so it wasn't a great job, but I can't see any crossed circuits from the solder), or something else is at fault.
Any ideas? I can't locate a replacement board online unfortunately - looks like they don't make parts for this model, and I'd rather not replace it if I can repair it.
-
22-10-2014, 08:28 PM #2
Re: Not receiving remote signal - older Fujitsu model split system
Sounds like you need replacement parts, these people can help you
http://spares.bigwarehouse.com.au/in...e5a1e30683f13b
-
23-10-2014, 12:04 AM #3
Re: Not receiving remote signal - older Fujitsu model split system
Thanks, I've had a look on there and it says the IR Receiver board is no longer available.
-
23-10-2014, 09:20 AM #4
Re: Not receiving remote signal - older Fujitsu model split system
Try these guys, i have used them before when parts are no longer available. Send in your remote and receiver.
http://www.modulerepair.com.au/
-
24-10-2014, 04:50 PM #5
- Join Date
- Sep 2007
- Location
- Split Croatia
- Age
- 57
- Posts
- 6,151
- Blog Entries
- 6
- Rep Power
- 36
Re: Not receiving remote signal - older Fujitsu model split system
Any TV repar shop could do that repair in 15 seconds!