Results 1 to 3 of 3
Thread: 248 volt, open winding
-
20-05-2014, 12:10 AM #1
248 volt, open winding
I have a 200v-230v 1 phase compressor that has the common winding open. Took power off, got back to it in 4 hours, same result, protector doesn't close. Checked voltage: 248 volts. Can this be the cause of the burn out?
-
20-05-2014, 12:44 AM #2
Re: 248 volt, open winding
.
That is about 8 - 9% over??
I know of sites that are rated 230v and we get 252v which is near to the 10% maximum.
It is possible, but probably unlikely.
Rob
... ... -. .----. - / -- --- .-. ... . / -.-. --- -.. . / --. --- --- -..
-
20-05-2014, 12:59 AM #3
Re: 248 volt, open winding
[QUOTE=Rob White;295950].
That is about 8 - 9% over??
I know of sites that are rated 230v and we get 252v which is near to the 10% maximum.
It is possible, but probably unlikely.
Rob
I will replace it tomorrow and will cut open the old one to see what happened.