Results 1 to 3 of 3
-
28-04-2014, 07:13 AM #1
YORK chiller ISN codepak control center showed a series of garbled signals.....
Hi, everyone,
Recently I started the YORK chiller ISN codepak control center...Firstly, it showed "DISPLAY SELF-TEST" on display panel, then it showed "SOFTWARE # 31916-02", and then it showed a series of garbled signals, like " !@#$%^&*()....." I already tried to enter any buttons on display panel...it just showed a series of garbled signals.....
I don't know how to solve it...I also reset the power and restart the mechine for many times! It still just showed garbled signals...
Please help me urgently~~and give me some ways to fix it!!!
Thanks for everyone.....
-
28-04-2014, 11:32 AM #2
Re: YORK chiller ISN codepak control center showed a series of garbled signals.....
Hi there
You may require the York Ice software to enable too reset this.
I suggest calling your local Johnson Controls office.
-
05-05-2014, 02:23 PM #3
Re: YORK chiller ISN codepak control center showed a series of garbled signals.....
Hi , that sound like a lose wire from your display or ram chip going bad. It could also be a dry joint under the PCB. Re-flow with solder and test again and check continuity with meter.
Regards