Results 1 to 7 of 7
-
23-04-2014, 07:37 PM #1
help me .. how I added oil to compressor for centrifugal chilled water
Dear brothers .. help me how to add oil and which lubricate the parts of Eombrisr when you start chiller type (liters) compressor centrifuges(trane), because the index of oil are very few, and there are traces of loss oil on pump, and we have to address exuding, but I don't know from anywhere added oil, Attach your photo and special pump oil in trane chilled water .so I hope the people of experience help me to know the place for adding oil, as exists with pictures attached and the possibility Tachireha Aalsourh Thank you very much
-
23-04-2014, 07:50 PM #2
Re: help me .. how I added oil to compressor for centrifugal chilled water
https://www.trane.com/Commercial/Upl...u02be4_205.pdf
page 81 explains how to drain oil and re fill
-
23-04-2014, 07:55 PM #3
Re: help me .. how I added oil to compressor for centrifugal chilled water
The 3/8" connection on the shut off valve under electrics box looks good. Do you have an oil pump? If so pump it in there. If not shut the compressor off, pull into a vacuum and suck it in there.
-
23-04-2014, 08:07 PM #4
Re: help me .. how I added oil to compressor for centrifugal chilled water
thanks dear Newmanref ....
Is is possible to place marking Add oil .. inecate on photo plz
-
23-04-2014, 08:17 PM #5
Re: help me .. how I added oil to compressor for centrifugal chilled water
-
23-04-2014, 08:29 PM #6
Re: help me .. how I added oil to compressor for centrifugal chilled water
-
23-04-2014, 08:50 PM #7
Re: help me .. how I added oil to compressor for centrifugal chilled water
u might need to zoom on the pic
image-1398270250431-V.jpg