Fujitsu Inverter

[mike1]

Hi All

I have a Fujitsu Inverter ASYG24LFCA. If I set the vent blades to a particular angle, after several hours it reverts back to its default position. This happens with the unit continuously turned on.

Does anyone know how I can change the default angle/position of the vent blades or get it to stay where I choose?

Thanks
Mike

[The Viking]

Well I don't know about any Fujitsu specific way...

But the old engineer's trick is to disconnect the linkage to the motor(s) and use superglue to fix the vane in position.

[install monkey]

on most splits in cooling mode if you set the sirflow downwards it will revert to a horizontal position- usually after an hour on a mitsi unit- its to prevent condensation forming on the flap- which rarely happens, only way is either unplug the louvre motor off the indoor pcb or set it to swing

Hi All

I have a Fujitsu Inverter ASYG24LFCA. If I set the vent blades to a particular angle, after several hours it reverts back to its default position. This happens with the unit continuously turned on.

Does anyone know how I can change the default angle/position of the vent blades or get it to stay where I choose?

Thanks
Mike

[frank]

As IM says...the only way to beat the computer is to unplug it

[mike1]

Thanks guys, the plug is out