Results 1 to 5 of 5
Thread: "Special" screw compressor
-
10-09-2013, 09:22 AM #1
"Special" screw compressor
Has anyone ever heard of a screw compressor which manufacturer has purposefully
machined tips of rotors at discharge end?
This is a Nh3 system which is in a gas field, have no other details.
-
10-09-2013, 02:48 PM #2
Re: "Special" screw compressor
Nope, but I'm no expert. Machined how, exactly?
-
10-09-2013, 10:25 PM #3
Re: "Special" screw compressor
It's impossible to make anything foolproof because fools are so ingenious...
Don't ever underestimate the power of stupid people when they are in large groups.
Please, don't teach me how to be stupid....
No job is as important as to jeopardize the safety of you or those that you work with.
-
11-09-2013, 08:58 AM #4
Re: "Special" screw compressor
I have not seen this machine but it was described to me with the machined of tips a discharge end.
It also makes no sense to me as that is the business end where heat & capacity are affected.
The only thing Mycom have done which is different to most screw compressor manufacturers, is to have booster or high side discharge end clearances different.
Makes you wonder if someone made a mistake somewhere.
Maybe a Mycom rep could answer?
-
11-09-2013, 10:21 AM #5
Re: "Special" screw compressor
I wonder if it was to de-rate the compressor for some specific reason? A special order or field modification?