Results 1 to 6 of 6
Threaded View
-
25-05-2013, 12:36 AM #1
Markers on armaflex for pipe joints?
I may have asked this before, but does anyone know if there is a standard for marking armaflex where there's a joint?
I might have an install coming up and its a tight budget, it will be the first one for a few years and the length of the pipe run will mean at least 2 joints outside accessable at low level. I was just going to use an indelable marker and simply write joint on the aramflex, But I didn't know if there now was a BS or EN for refrigeration/aircon pipe work that actually meant anything? As the Refcom site is just a phone directory with no ads.Training may be finished but experience is never complete.