Have had a few issues with Danfoss valves & wonder if anyone else had same issues.

ICS control module or inserts have been inproved & modified.
Original you could not pull apart, so have improved so you can.
I replaced a ICS 25-25 module from old style to new style. Have found that "0" ring groove area fouls with body internals not allowing module insert to go into place. If you bolt top on i will crush bottom part of "0" ring groove.

Also one of our clients has complaint of using EVRAT solenoid repair kits in older style EVRA valves & manual jacking spindle will not open valve (to short).
Yes we have been supplying old stle EVRAT repair kits in EVRA valves.
Danfoss will only supply us EVRAT repair kit, not sure if it is a worldwide thing.

Danfoss have been advised, but does anyone else have experienced these issues?