Results 1 to 3 of 3

Thread: T800

  1. 29-04-2012, 05:31 PM #1
    s4ndy's Avatar
    s4ndy
    s4ndy is offline rookie poster
    Join Date
    Jun 2010
    Location
    perthshire
    Age
    48
    Posts
    13
    Rep Power
    0

    T800



    Hello everyone, Just seen a thermoking T800 for the first time cutting out on high pressure when unit on heat a live feed to hot gas valve but no earth from micro does any one have a diagram they can send me or is there any common faults on these units i should look for?
    Sandy

    sandyinperth@btinternet.com


  2. 01-05-2012, 12:24 AM #2
    moggy66's Avatar
    moggy66
    moggy66 is offline regular poster
    Join Date
    Nov 2009
    Location
    Canada
    Posts
    123
    Rep Power
    15

    Re: T800

    I thought the T/K's switched the +ve from the micro not the ground,when its not in heat is there 12v to the solinoid then? if not you have a ground fault.
  3. 01-05-2012, 07:03 AM #3
    gravy258's Avatar
    gravy258
    gravy258 is offline Veteran Poster
    Join Date
    Dec 2007
    Location
    Melbourne
    Posts
    347
    Rep Power
    18

    Re: T800

    not much to see on the wiring diagram, micro gives signal, LED10 lights up on relay board +ve to HGS, permanent earth.
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules