I am looking for frick 3519(i think just 355 tools) tools, or drawings on them so i can get some buuilt. i have a 3519 to overhaul in june and am hoping to have them made up before hand. if anyone can help that would be very kind of you.
I use a hollow shaft 10 ton porta power, a variety of threaded rod, impact wrench, 3/8" thick piece of plate ( size of bearing covers ), oil bath or induction heater for bearings, a variety of pipe ( different lengths and diameters to fit over shafts ) and a 3/4 ton chain hoist ( ratchet style ). Construct lock nut wrenches as needed using large sockets and key stock.
Last edited by CanadianIce; 21-04-2012 at 10:10 PM.
Reason: Left out some information
Thanks for the advise Peter. I unfortunately haven't got the capacity in my reclaim bottle to take the full charge. I was thinking about connecting the reclaim bottle onto the bleed valve on the top...
This forum and its pages must not be copied or reprinted without the written consent of Refrigeration Engineer.com. This forum is a free and open discussion board. Refrigeration-Engineer.com, the administrators and Moderators of this site are not responsible for content posted here.