Results 1 to 14 of 14
Thread: Frick screw bearing damage
-
08-10-2011, 12:14 AM #1
Frick screw bearing damage
Hoping someone can assist, with analyizing main roller bearing damage in a Frick screw
on ammonia.
I have previously seen an article on Frick oil filters also showing damaged bearings &
cause of bearing damage.
Thanks Ranger
-
10-10-2011, 05:43 AM #2
Re: Frick screw bearing damage
Hi Ranger
What is the damage to the bearings.
Have you asked a bearing supplier for their opinion sometimes they will help.
Paul
-
10-10-2011, 11:30 AM #3
Re: Frick screw bearing damage
Paul,
Damage to drive end bearing male rotor is a little unusual.
It has a spiralling heavy wear pattern.
I could ask bearing supplier, but sometimes difficult if you did'nt buy bearings
off them, as we are using genuine frick bearings.
Thanks for advise
-
11-10-2011, 01:13 AM #4
Re: Frick screw bearing damage
http://www.irc.wisc.edu/file.php?id=214 here's a good article on bearing failures
-
11-10-2011, 09:18 PM #5
-
14-10-2011, 12:28 AM #6
Re: Frick screw bearing damage
Hi Ranger1
Have you a photo or two we call look at?
-
19-10-2011, 11:28 PM #7
Re: Frick screw bearing damage
Hi ,
Do you check the coupling of compressor and drive? it should be adjusted according to the manual . may be the angle of spacer of coupling is not correct.
Regards
-
13-12-2011, 04:31 PM #8
Re: Frick screw bearing damage
In our cases, we mostly see damage to the male thrust bearings first. Also, I highly doubt that a bearing supply house provides genuine Frick bearings, which to my knowledge are SKF. In my experience, you need to be careful of avoid using jobber bearings as Frick may have specified a certain internal clearance (C3, C4's) or other specifics which you simply cannot decipher by reading the bearing number off the race.
-
15-12-2011, 10:23 PM #9
Re: Frick screw bearing damage
hello. please what is the axial compressor frick HSDD 233l, some change in this play if it works in -10 ° C and -35 ° c is working, grateful
-
15-12-2011, 10:24 PM #10
Re: Frick screw bearing damage
hello. please what is the axial compressor FRICK TDSH 233L
, some change in this play if it works in -10 ° C and -35 ° c is working, grateful
-
16-12-2011, 11:33 AM #11
Re: Frick screw bearing damage
Diego is not a problem, Frick does not separate low and high.
-
18-12-2011, 02:29 AM #12
Re: Frick screw bearing damage
What is the tolerance of slack in the thrust bearings 233 FRICK??
-
18-12-2011, 07:19 AM #13
-
29-12-2011, 07:38 PM #14