Results 1 to 9 of 9
Thread: Denco D12A
-
20-09-2011, 10:19 AM #1
Denco D12A
does anyone have a controls manual for the above unit it's a trend controller iq20
Thanks James
-
20-09-2011, 09:25 PM #2
Re: Denco D12A
denco technical -aka rob woodworth rob.woodworth@geagroup.com
-
20-09-2011, 09:31 PM #3
Re: Denco D12A
Cheers monkey, got passwords from him didn't want to pester him twice for manual aswell
-
20-09-2011, 10:02 PM #4
Re: Denco D12A
he's the man-thats what he's paid for.
is that the controller before the milenium-with 4 password levels and a factory level up up up?
-
20-09-2011, 10:42 PM #5
Re: Denco D12A
No, it's a trend controller just has up and down arrows and+ - symbols on it not sure about password levels I only wanted to alter the setpoint password was 1286 FYI
Last edited by james10; 21-09-2011 at 08:10 AM.
-
20-09-2011, 10:49 PM #6
Re: Denco D12A
ta bud-trend generic access code 0403
-
20-09-2011, 11:31 PM #7
Re: Denco D12A
Cheers mate I'll note that one down
-
22-09-2011, 07:13 PM #8
Re: Denco D12A
There wont be a manual for the TREND products as each units' software is written specifically for that JOB.
Therefore a manual would be of no help.
As a side note. The Software is written by Geoff at the Factory. He left the Navy in December 1986. Hence the 1286 password
Push the UP arrow until the cursor is under the top line
Press the + until KNOBS is displayed
Press the down arrow once so that the cursor moves to the middle line of text
Press + until the correct KNOB is displayed (usually KNOB 3 is Temp Setpoint)
Press the down arrow until the cursor is under the Temp Setpoint
Press + or - until the desired temperature is required
and ta-da! Job done.
Sign here, tarra-a-bit!!
-
22-09-2011, 07:41 PM #9