Reliable Oil Pump Brand for Ammonia Screw Compressors

[RANGER1]

Mycom & Viking are good but synthetic oil can cause some issues with seals leaking.
HNBR '0' rings are common with Sabroe & Mycom in some newer shaft seals.

[blackergp]

Thanks RANGER1

[lloydjosang]

I used to come across packages built by Kværner from Norway that used Kral oil pumps. I think you can find them through their representative in Turkey
Tantek Tek. HIz. Ltd.
Perpa Tic. Merk. A Bl., K 11
No. 1419
34385 Okmeydani - Istanbul
TURKEY

Tel.: (+90) 21 22 21 16 56
Fax: (+90) 21 22 20 44 64
e-mail

Mr. Haluk Saltan

or you can go on their website and see what you find. www.krat.at

Also Mycom (Mayekawa) oil pumps are pretty reliable I have worked with a lot of their M50-P pumps.

http://www.mayekawa.eu/contact/contact.html

Lloyd

[Tycho]

I used to come across packages built by Kværner from Norway that used Kral oil pumps. I think you can find them through their representative in Turkey
Tantek Tek. HIz. Ltd.
Perpa Tic. Merk. A Bl., K 11
No. 1419
34385 Okmeydani - Istanbul
TURKEY

Tel.: (+90) 21 22 21 16 56
Fax: (+90) 21 22 20 44 64
e-mail

Mr. Haluk Saltan

or you can go on their website and see what you find. www.krat.at

Also Mycom (Mayekawa) oil pumps are pretty reliable I have worked with a lot of their M50-P pumps.

http://www.mayekawa.eu/contact/contact.html

Lloyd

Yeah, we used to deliver the units with the KRAL MFUG 55 pump, but the last 15 years we have been using the Viking pump with no problems.

As long as you have a good oil temperature, and don't run it dry it should have the same service intervals as the compressor

Oh and specify that the pump is to be used in an ammonia system, you will get a pump designed for it

[blackergp]

Thanks lloydjosang !