Results 1 to 3 of 3
Thread: Old Sentronic to a new OPS2
-
10-08-2011, 08:24 PM #1
Old Sentronic to a new OPS2
25 hp Copeland compressor, trips on oil pressure control.
Sensor does not work. Checked the oil pressure - 120psi, fine by me.
Only controller supplier had was the OPS2.
Wiring is different and it has 6 wires instead of the Sentronic.
Any one have done such a change? I would like to hear about it.
Thanks.
-
11-08-2011, 12:47 AM #2
Re: Old Sentronic to a new OPS2
Hi Chemi.
The attached may help?
I will also send some more detailed info via email.
Grizzly
-
11-08-2011, 01:48 AM #3
Re: Old Sentronic to a new OPS2
Hi Chemi-cool.
prefer the 4 wire connection set up, control switch in and out two wires, power supply from contactor supply and neutral 2 wires. OPswitch activated when contactor is activeted.