Results 1 to 8 of 8
Thread: S87 stal screw
-
10-12-2010, 09:27 AM #1
S87 stal screw
Can someone please assist in supplying shaft seal area dimention for S87 Stal
Shaft seal area damaged & require correct measurement to repair seal area .
Thanks
-
10-12-2010, 12:24 PM #2
Re: S87 stal screw
Single or double?
-
10-12-2010, 09:42 PM #3
Re: S87 stal screw
josef,
Could only describe it as standard single seal .
Machine is 7 yrs old & seal area approx 80mm
What is double seal all about , is it something new?
-
11-12-2010, 02:24 PM #4
Re: S87 stal screw
Hi Ranger.
Sadly I only have the normal parts list which I assume you already have.
That only has the minimum of information.
Anyway good luck.
Grizzly.
-
08-01-2011, 01:37 PM #5
Re: S87 stal screw
I think Josef may be refering to a modification made to the shaft seal which included an extra sealing ring to prevent oil from draining out of the shaft seal during idle periods.
Ginge
-
08-01-2011, 08:42 PM #6
Re: S87 stal screw
Gingerair,
Yes that was 1 upgrade also I think that the bellows that slides onto the shaft has 2 "0" rings now insead of 1 for higher pressure refrigerants.
-
09-01-2011, 09:23 PM #7
Re: S87 stal screw
Hi Ranger
Sounds like you've got sorted, but if not i may know someone that may be able to help you out with a new seal.
Ginge
-
12-02-2011, 07:32 PM #8
Re: S87 stal screw
Please contact johnson controls denmark an ask for the repshop/tonny jørgensen
Similar Threads
-
Service manual for STAL Screw compressor
By pfwousv in forum Industrial CompressorsReplies: 3Last Post: 23-08-2011, 07:17 PM -
Stal vertical screw compressor
By Kota.Kumar in forum Technical DiscussionsReplies: 8Last Post: 06-11-2010, 08:17 AM -
Compressors - screw or reciprocating?
By Josip in forum Industrial CompressorsReplies: 18Last Post: 27-01-2009, 10:36 PM -
STAL SRM SCREW compressor
By graeme ellis in forum Industrial CompressorsReplies: 7Last Post: 15-03-2007, 02:01 AM -
Stal Screw Compressor R5-mkii 100kw
By REFSOO in forum Trouble ShootingReplies: 1Last Post: 20-01-2007, 01:09 AM