Results 1 to 3 of 3
Thread: Frick screws with bell housing
-
01-12-2010, 08:07 PM #1
Frick screws with bell housing
Can anyone advise on new style Fricks with bell housing , eg 283
If you need to change shaft seal do you have to remove main drive motor to get to it or can it be done without disturbing it ?
Thanks
-
01-12-2010, 08:43 PM #2
Re: Frick screws with bell housing
Ranger1 No, you do not remove the motor.
-
18-12-2010, 07:41 AM #3
Re: Frick screws with bell housing
It's a very simple exercise, you will have to make a few tools, but other than that, no problem for a qualified engineer.
Similar Threads
-
Are Copeland screws any good?
By garyb in forum CommercialReplies: 13Last Post: 08-06-2010, 06:47 AM -
FRICK TDSH 233 Slide Valve and guide damaged
By 404cab in forum Industrial CompressorsReplies: 9Last Post: 30-07-2008, 11:24 PM -
Ammonia Circulation rate - by Frick/ Vitler
By smpsmp45 in forum NH3Replies: 12Last Post: 16-06-2008, 10:06 AM -
New Sabroe (Frick) Screws
By Andy in forum Industrial CompressorsReplies: 22Last Post: 21-05-2008, 04:28 PM -
Frick screws,,, Any good,?
By petrock in forum Industrial CompressorsReplies: 10Last Post: 24-11-2007, 05:03 PM