Results 1 to 5 of 5
Thread: "SPECIAL" screw compressor
-
06-11-2010, 08:07 AM #1
"SPECIAL" screw compressor
Have a process application which would run under following conditions .
NH3 Economized VSD -33 C SST
+ 48 C SDT
Apart from possible higher pressure rated casting would anything else have to be "SPECIAL" about it ?
Anyone have experience ?
-
06-11-2010, 10:05 AM #2
Re: "SPECIAL" screw compressor
Why not a normal cascade system with NH3 on the low stage, and some other natural refrigerant on the high stage?
-
06-11-2010, 05:13 PM #3
Re: "SPECIAL" screw compressor
-
22-11-2010, 11:35 PM #4
Re: "SPECIAL" screw compressor
Air cooled on R-717 is comparable to these conditions; considerable data on that in the IIAR technical sessions. Also more recently on using R-717 in central heat pump arrangements. Check the Vilter web site; they did nice work on a "small channel" single rotor screw for such purposes; high side to 85-deg C condensing.
http://www.emersonclimate.com/Docume...%20Version.pdf
-
24-11-2010, 06:48 PM #5
Re: "SPECIAL" screw compressor
Limits on Vilter standard Single Screws are MAWP above 33 bar and pressure ratio 20:1.
This application is within the limits, no need for their special high pressure compressors (MAWP 75 bar).
Similar Threads
-
Stal vertical screw compressor
By Kota.Kumar in forum Technical DiscussionsReplies: 8Last Post: 06-11-2010, 08:17 AM -
Liquid hammering problem on screw compressor in ammonia refrigeration system
By ghanghas85 in forum Trouble ShootingReplies: 2Last Post: 19-10-2010, 08:56 PM -
Screw compressor failure
By christossev in forum IndustrialReplies: 4Last Post: 15-10-2010, 07:26 PM -
problem with volume on frick screw compressor
By samlee12 in forum IndustrialReplies: 4Last Post: 29-10-2009, 06:06 AM -
advantage of twin screw compressor over single screw compressor
By azzah in forum New to REReplies: 7Last Post: 23-09-2008, 09:24 AM