Results 1 to 9 of 9
Thread: capillary sizing for R404a
-
11-07-2005, 11:33 AM #1
capillary sizing for R404a
hi there would anyone be able to tell me where i could find capillary sizing charts for R404a
-
11-07-2005, 12:35 PM #2
Re: capillary sizing for R404a
Do a search on 'capillary tube' on this forum
Lots of links
Or use the free software from Tecumseh / Unithé Hermétique .It's better to keep your mouth shut and give the impression that you're stupid than to open it and remove all doubt.
-
20-08-2005, 12:18 AM #3
Re-Capillary sizing programs
I have seen a capillary sizing program in use by a local parts supplier. It gives options for bore\length of capil. I have been using a service sheet that came with a "SP 1" capillary service pack from Australia for a long time. No complaints, but this program looks very handy. Any suggetions where one could be obtained. The local supplier is reluctant to impart this information.
-
20-08-2005, 12:34 AM #4
Re: capillary sizing for R404a
I tried Tecumseh's Europe, completed their enrolement and received a pdf file that told me to check the capillary sizing chart attatched. Problem was, there was no attatchment. Repeated the process 3 times, still no chart. I'm currently awaiting a reply from key@cyburbia.net.au The site of "Key Tubing Electrical Systems" the producers of the "SP service packs" "down-under"
-
29-09-2005, 07:23 PM #5
Re: capillary sizing for R404a
if you ask most technical helplines they will usually tell you ie fosters etc
-
19-03-2008, 12:42 PM #6
Re: capillary sizing for R404a
You can also use Danfoss program, to size Capillary Tubes. Look in danfoss.com
/BusinessAreas/RefrigerationAndAirConditioning/Software/
guides you to the page where you can download the program.
-
19-03-2008, 02:58 PM #7
Re: capillary sizing for R404a
There is a Danfoss software known as Dancap. You can select the capillary sizes for a number of refrigerants including 404A.
You may visit the website of Danfoss and search for software. You will find the link for download. If you have problem, please let me know, I shall post the link.
-
19-03-2008, 03:02 PM #8
Re: capillary sizing for R404a
-
19-03-2008, 07:27 PM #9
Re: capillary sizing for R404a
The original question is almost three years old now but thanks for updating the links
Brian - Newton Abbot, Devon, UK
Retired March 2015
Similar Threads
-
:rolleyes: capillary tube size in distributor?
By abbasi in forum New TechnologiesReplies: 2Last Post: 08-07-2006, 03:56 PM -
Sizing for Australia
By dogma in forum FundamentalsReplies: 5Last Post: 17-03-2006, 10:05 AM -
metric capillary tube
By tralex in forum FundamentalsReplies: 5Last Post: 21-02-2006, 06:57 AM -
capillary tubes and mass flow when fed with liquid/gas
By DaBit in forum FundamentalsReplies: 15Last Post: 24-10-2002, 06:52 PM